If you meant (a popular laser engraver/CNC control board), here’s what you’re likely looking for:
The is a powerful, open-source offline controller designed specifically for CNC engraving and laser cutting machines. Official Documentation & Manuals
See – The board uses a PTC fuse rated for 15A total. Do not exceed this. With a 24V power supply, your bed heater should not draw more than 10A-12A, leaving headroom for motors and hotend.
: A visual guide is available via the MKS DLC32 V2.1 Pinout and Wiring Guide on Scribd . The Bridge Between Code and Craft: The MKS DLC v2.1
If you're having trouble with a specific part of the setup, let me know: Are you using it for a Laser Engraver CNC Router Do you have the 8-bit (standard DLC) 32-bit (DLC32) Are you stuck on firmware flashing software connection
