Zpao Electric | Bike Manual

A: Use Google Lens on your phone. Hold the camera over the manual, tap "Translate." For the wiring diagram specifically, email support for the English "Electrical Schematic."

The official Zpao manual dedicates 12 pages to the battery—for good reason. The battery is 60% of the bike's value. Zpao Electric Bike Manual

| Code | Function | Zpao Default Setting | Explanation | | :--- | :--- | :--- | :--- | | | Backlight Brightness | 03 (Max) | Reduce to 01 for daytime battery saving. | | P02 | Odometer Reset | 0 | Set to 1 to clear trip (do not touch P02 if you want permanent total miles). | | P03 | Voltage | 48V (most models) | Do not change unless you have a 52V or 36V rare model. | | P04 | Auto Sleep Timer (min) | 10 | Time before display shuts off idle. | | P05 | Pedal Assist Sensitivity | 3 (Medium) | 1 = slow response, 5 = instant torque. | | P06 | Wheel Diameter (inches) | 26 (fat tire) / 20 (folding) | Incorrect setting ruins speedometer accuracy. | | P07 | Speed Limit (km/h) | 25 (EU) / 32 (US) | In the US, you can increase to 40 km/h for off-road. Warning: Illegal for street use. | | P08 | Throttle Mode | 0 (Throttle works at any PAS level) | 1 (Throttle only works above PAS 1). | | P09 | Walk Mode Speed | 6 km/h | Do not exceed 6 km/h to avoid motor jerking. | | P10 | PAS Start-up Strength | 2 | Higher values cause "lurching" starts. | A: Use Google Lens on your phone

A: Yes, but the manual says "IP54 rating" – meaning splashes are fine, but submerging the controller or display kills it. Never leave it in a downpour. | Code | Function | Zpao Default Setting