V2000-c Rfid Access Control User Manual Work -

and multiple entry modes including RFID cards (125KHz), PIN codes, or a combination of both. Sesame Access Co., Ltd. Technical Specifications Specification Power Supply 12VDC ± 10% User Capacity 1000 users Reading Distance 3 – 8 cm (1.18~2.36in) 125KHz EM Standard Unlock Relay Door Open Time Adjustable from 0 to 99 seconds Dimensions 119 x 76 x 21 mm (some models 118 x 118 x 20 mm) Installation and Wiring The unit should be mounted approximately 1.2 meters above the ground and roughly 0.5 meters from the door for optimal accessibility. +12V DC power. Black Wire: GND (Ground). Purple Wires: Doorbell button output. Wiegand Interface:

Access control has evolved from keyed doors and bulky card readers to sleek, secure RFID systems that balance convenience with safety. The V2000-c is a modern RFID access control unit designed for small-to-medium businesses, multi-tenant buildings, and organizations that want an affordable, reliable way to manage entry. This post walks through everything you need to know: features, installation, setup, daily use, troubleshooting, security considerations, and smart tips to get the most from your V2000-c. V2000-c Rfid Access Control User Manual

The V2000-C system is designed to be easy to use, with a simple and intuitive interface that allows administrators to manage access control with ease. The system can be operated using a variety of methods, including: and multiple entry modes including RFID cards (125KHz),

It is designed for single-door control (electric lock, exit button, alarm, door sensor). +12V DC power

The V2000-C RFID access control system comes with a comprehensive user manual that provides detailed instructions on installation, configuration, and operation. Here are some key configuration steps:

To enter programming mode, you must use the . The default master code is usually 990101 or 123456 . Enter/Exit Programming Mode Press * + [Master Code] + # . (The LED will turn red/flash). Press * to exit programming mode at any time. Change the Master Code

End of Report